[Buildroot] [PATCH v4] solidrun/macchiatobin: add new board
Sergey Matyukevich
geomatsi at gmail.com
Sun Dec 10 09:09:22 UTC 2017
Hello Baruch,
> Hi Sergey,
>
> On Sat, Dec 09, 2017 at 03:17:20PM +0300, Sergey Matyukevich wrote:
> > Add MacchiatoBin board by SolidRun. This board is based on Marvell
> > Armada 8040 SoC. Board support package includes the following
> > two options: mainline and vendor BSPs.
> >
> > Mainline BSP:
> > - Marvell ATF v1.3-armada-17.10
> > - mainline U-Boot v2017.11
> > - mainline Linux kernel v4.14.4
> >
> > Marvell BSP with more hardware support enabled:
> > - Marvell ATF v1.3-armada-17.10
> > - Marvell U-Boot based on v2017.03
> > - Marvell Linux kernel based v4.4.52
> >
> > More details about this board are available on wiki:
> > - http://wiki.macchiatobin.net
> >
> > Signed-off-by: Sergey Matyukevich <geomatsi at gmail.com>
> > ---
>
> [...]
>
> > +How to boot the board
> > +=====================
> > +
> > +MacchiatoBin board can be setup to load bootloader from different
> > +sources including eMMC, SPI flash, and SD-card. In order to select
> > +boot from SD-card DIP switches SW1 and SW2 should be configured
> > +as follows:
> > +SW2: 01110
> > +SW1: 1xxxx
>
> The upcoming revision 1.3 of the Macchiatobin will have a single pins header
> (J1) instead of the SW1/2 DIP switches. The setting of J1 jumpers matches the
> DIP switches of earlier revisions from left to right:
>
> 011101xxxx
>
> This is also marked on the PCB.
Thanks, noted. I plan to update mcbin board files after kernel v4.15 is out.
So I will queue this board info update into that change as well.
Regards,
Sergey
More information about the buildroot
mailing list