[Buildroot] [PATCH v1 2/2] configs/zynqmp_zcu106_defconfig: transition to tarballs

[Peter Korsgaard]

>>>>> "Michal" == Michal Simek <michal.simek at xilinx.com> writes:

Hi,

 >> > This is caused by not proper psu_init which setup PLLs incorrectly.
 >> This is using the psu_init_gpl.c in U-Boot:
 >> https://github.com/Xilinx/u-boot-xlnx/blob/xlnx_rebase_v2022.01_2022.1/board/xilinx/zynqmp/zynqmp-zcu106-revA/psu_init_gpl.c
 >> And the pmu configuration object from Neal:
 >> https://git.buildroot.net/buildroot/tree/board/zynqmp/zcu106/pm_cfg_obj.c
 >> So what exactly needs to change?

 > I don't have this board here that's why likely taken from any old
 > design before this check was added to Linux.
 > U-Boot psu_init_gpl.c should be updated.

Ok, I also only have temporary access to a zcu106. Neal/Michal, will you
take care of it?

-- 
Bye, Peter Korsgaard